Avery Dennison Monarch 9906 MonarchNet2 - Manual (Page 37)

Using a Web Browser 3-11
14. Enter the Pre-shared key, which must be exactly 64 hex characters. If using a pass-
phrase, it must be 8 to 63 displayable characters.
15. Set the Authentication Protocol: PAP, or MSCHAP_V2. See “Basic Security
Configurations” for more information.
16. Enter the User ID.
17. Enter the Password.
18. Click Submit when you are finished.
19. Click the Protocols tab.
20. Click Save Re-init Network (on the Protocols tab) before any changes take effect.
Even though you submitted your changes on the previous screen, they do not take
effect until you click Save Re-init Network. This process takes a few minutes.
Using WEP
If you select 64 BIT Encryption or 128 BIT Encryption, you need to enter the WEP keys.
1. Determine which Key Selection to use: 1-4.
2. Set the WEP Key values. You must use the same key values for devices to
communicate with each other on the network.
Note: As you enter the values for the WEP keys, you can see the characters.
However, the next time you view this tab, the values are displayed as asterisks
(*).
3. Click Submit when finished.
4. Click the Protocols tab.
5. Click Save Re-init Network (on the Protocols tab) before any changes take effect.
Even though you submitted your changes on the previous screen, they do not take
effect until you click Save Re-init Network. This process takes a few minutes.