Avery Dennison Monarch 9906 MonarchNet2 User Manual

Page 50

Advertising
background image

4-6

MonarchNet2 Operating Instructions

8 0 2 . 1 1 b / g W i r e l e s s C o m m a n d s

In the following commands, EN and NW (network settings) are interchangeable.

CLear EN SSid

Clears the SSID, so the server connects to any access point.

SET EN

Sets 802.11b/g Wireless Settings.

SET EN APDEN [LOW/MED/HI]

Sets 802.11b/g access point density.

SET EN AUTHtype [OPEN/SHARED/TTLS/LEAP/PEAP/WPA-PSK]

Sets the authentication type. See Chapter 3, “

Using the Web Browser

” for more information.

SET EN CERTCN <name>

Sets the EAP common name. If no value is set (null), all host certificates are accepted.

SET EN CERTCN2 <name>

Sets the second EAP common name. If no value is set (null), all host certificates are accepted.

SET EN CERTEXP <value>

Sets the EAP certificate exponent value.

SET EN CERTKEY <keyvalue>

Sets the EAP root key value.

SET EN CHannel nn

Sets 802.11b/g wireless channel.

SET EN ENC [DISable/64/128/WPA/WPA2/WPA2-WPA/

Dynamic WEP]

Sets the encryption mode. See Chapter 3, “

Using the Web Browser

” for more information.

SET EN ID <userID>

Sets the authentication user ID. It may include the realm, separated with the “at” (“@”)
character.

SET EN INAP [PAP/MSCHAP_V2]

Sets the EAP inner authentication protocol.

SET EN IROAM [DISable/STRICT/FLEXible]

Controls whether the radio frequencies are set based on the radio configuration or from its
access point. Disabled uses the radio defaults. When in Ad-Hoc mode, you must set the region
of operation. See “SET EN REGDOMain”. Flexible uses access point settings if present,
otherwise the radio defaults are used. When in Ad-Hoc mode, you must set the region of
operation. See “SET EN REGDOMain”. Strict uses access point regulatory frequency
information. When using an access point, there is no need to set the region of operation.

SET EN PW <password>

Sets the password for 802.11b/g EAP authentication.

SET EN KEY# <1/2/3/4>

Sets which WEP key number to use (default is 1).

SET EN KEYVAL <WEPkey>

Sets WEP key value. Must be hexadecimal.

Advertising