Avery Dennison SNAP 700 RFID Linear Knife User Manual
Page 19
Snap Linear Knife
Adjustments
19
8. Run the printer again and see if there is a walking issue, if so repeat steps 4-6.
9. If the stock wants to walk toward the front of the printer, then position the feed assembly so that the outer
edge move slightly away from the stacker side, and reverse steps as previously stated.
10. Once the stock is tracking through the printer without walking, the feed assembly can be secured.
11. The Printer is now ready for the latest Operating System Installation. Download and install Operating
System Version 3.32.07.05 or later.
Setting the Web Guide
The web guide is located between the tag stock supply roll and the first print station in the web path. To set the
web guide correctly, get the tracking of the printer centered first. There are two set collars with thumbs screws
that will rest just off the material. Position these collars to steer the web correctly through the printer. Do not
try and force the stock more then 1/4” (5mm) as it can damage the edge of the tag stock.
Loosen Screws
Use “Jack” Set
Screws to position
the Feed Assembly
one way or the other.