Centering the knife to the web – Avery Dennison SNAP 700 RFID Linear Knife User Manual
Page 29
Advertising
Snap Linear Knife
Adjustments
29
Centering the Knife to the Web
After the web is tracking through the printer and into the knife straight, it may
still need to be centered going into the knife.
1.
Turn off power to the printer.
Unplug the stacker and remove it from the
linear knife.
Unplug the Linear Knife from the Snap
700 printer.
2.
Remove the feed knob and the sensor
adjust knob.
For clarity purposes the knife if shown not
attached to the printer. These instructions
are stepped as if the knife was attached to a
printer.
3.
Remove three 8-32 button head screws and
the left side cover
Advertising