Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 42)

42

Snap Linear Knife
7. Remove the last two screws holding the
motherboard entry bracket to the base
frame.
Remove motherboard entry bracket.
8. With the motherboard entry bracket
removed the printer should look something
like this…
.
9. Install the new motherboard entry bracket
(with the 5 existing screws) back into the
same place the old one was removed.
Notice the new bracket now has three
accessory openings for mounting harness
connectors.
Remove PCI bracket from existing
motherboard entry bracket and place onto
the new bracket with the same screw.
10. Install the existing motherboard plate into
the opening on the new mother board entry
bracket.
Slide the motherboard back into place and
secure with the screws from step 4.