Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 52)

52

Snap Linear Knife
Installing the Stacker on the Linear Knife
The stacker that was removed from the printer will be used on the accessory
knife.
1. Remove the stacker mount on the back of
the stacker and replace it with the Stacker
Mount Block supplied with the Linear
Knife (P/N: 05627843).
2. Slide the stacker onto the two shafts of the
knife assembly. The back of the stacker
must be in back of the nip assembly
stripper plate. This allows the cut tags to
fall into the stacker and not catch on the
stacker frame.
3.
Move the stacker’s back until the stacker
upright is approx 1/8” past the back edge
of the web.