Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 36)

36

Appendix A Snap Linear Knife
Removing the Nip Assembly
The Linear Knife will use the existing nip assembly and mount hardware from
the printer.
1. The nip assembly is removed with a long
#2 Phillips screw driver. Loosen the two
10-32 X ¾” Phillips head screws that
mount the assembly to the frame and then
remove the two screws.
2. Save the nip assembly and the two screws.
They will be used to remount the assembly
to the new linear knife.