Installing the nip assembly – Avery Dennison SNAP 700 RFID Linear Knife User Manual
Page 50
Advertising
50
Snap Linear Knife
Installing the Nip Assembly
The nip assembly that was removed from the printer to make room for the new
knife will be installed on the Linear knife. Skip this section if the Linear Knife
already has a Nip Roller Assembly.
1.
The nip assembly will be installed using
the same screws that mounted it to the
Printer.
2.
Place the top screw back through the
original mount hole and install the screw
but leave it loose by approx 3/8” (9mm).
Start the bottom screw but do not tighten
that screw as well.
3.
Push the nip assembly towards the frame
that it’s being mounted to and turn the
shaft to engage the drive with the driven
roller.
Advertising