Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 35)

Snap Linear Knife Appendix A

35
Appendix A
The SNAP 700 Printer will need minor alterations to have a Linear Knife
installed. These alterations apply to both a new printer and a field installation.
For new printer installation, see instruction “Installing the Linear Knife” and
“Installing the Stacker on the Linear Knife”.
For field installation, replace the original equipment rotary knife by beginning
below.
NOTE: Avoid personal injury or damage to the electronics in the printer by
turning off the printer and disconnect the power cord.
Removing the Stacker
Remove the stacker as shown. It will be installed later on the Linear Knife.
1. Unplug the stacker cable from the printer.
There is an outer ring in the stacker
connector that will slide back to release the
cable connection.
2. Loosen the thumb screw that clamps the
stacker to the mount shafts.
Slide stacker off the mount shafts and set
aside to be installed later.
Note: The two mount shafts are used to
mount the Linear Knife.