Upstream switch, Upstream switch -21, Figure 3-21 point-to-mulitpoint inband receivers – Comtech EF Data Vipersat Circuit Scheduler v3.7.x ArrangeLink User Manual
Page 63: Figure 3-22 remove receiver from list
Advertising
Chapter
3 -
Using ArrangeLink
3-21
Schedule Setup
Figure 3-21 Point-to-Mulitpoint InBand Receivers
Figure 3-22 Remove Receiver from List
When configuration of the Circuit Specific Options is completed, click on the
Continue button to proceed to the Advanced Switching tab.
Upstream Switch
Because an Upstream Switch is always between a Remote and the Hub, only a
single Point has to be specified—the Remote site. An Upstream Switch event
can be scheduled using the following procedure:
Advertising