Comtech EF Data Vipersat Circuit Scheduler v3.7.x ArrangeLink - Manual (Page 73)

Chapter 3 - Using ArrangeLink 3-31
Schedule View
• Mobile – indicates if this schedule is for a mobile application.
• Transmitter – identifies the Remote site ID of the transmitter for this
event.
• Receiver – identifies the Remote site ID(s) of the receiver(s) for this
event.
Resource allocation details for a Running event are presented in the lower panel.
• For the Transmitter (top row of the table):
• Channel – the assigned channel for transmitting.
• Frequency (MHz) – the assigned transmit frequency.
• Bandwidth (kHz) – the allocated bandwidth for transmitting.
• Device type – the assigned transmit modulator.
• Device Name – the name of the modulator.
• For the Receiver(s) (lower row(s) of the table):
• Device type – the assigned receive demodulator(s).
• Device Name – the name(s) of the demodulator(s).
• Power (dBm) – the received power level.
• E
b
/N
o
(dB) – the received signal quality level.
Schedules Details
In comparison, the details for the Daily Point-to-Multipoint event that is
selected in the Schedules screen example (figure 3-27) is shown in figure 3-30,
below.
The upper panel of this screen presents the following details:
• Schedule Name – the name assigned to this schedule.
• Schedule Type – the type of event for this schedule.
• Circuit/Rate/Priority – the specified circuit type, data rate (kbps), and
priority level.
• Date Range – the start date and end date for this event or set of events.
• Max. ExecDelay – the time interval specified for the Maximum
Execution Delay parameter.
• Recurrence – the recurrence interval established for this schedule type.