Daktronics CARS - Manual (Page 58)

If “Procomm” is used, set it for “Wyse 50” emulation mode and configure the
communications options to match the Wyse terminal setup on the following page. Set
Procomm to use com1 or com2 and connect the “null modem” cable to the appropriate port.
CARS will access the PC in the same way as a Wyse terminal, as described at the start of this
Appendix.
WY30 Terminal Setup
Use the following Wyse 30 setup when using the Wyse terminal as an announcer’s monitor with
CARS.
Appendix C: Announcer’s Monitor C-4