Datatek DT-4180 - Manual (Page 105)

9 4 8 0 , 4 1 8 0 , 4 2 8 0 , 4 2 8 4 4 0 0 0 X A U s e r M a n u a l
04/09/09
105
17.8.3 Industry Canada CS03 Certification Information
NOTICE: The Industry Canada label identifies certified equipment. This certification
means that the equipment meets the telecommunications network protective, operational
and safety requirements as prescribed in the appropriate Terminal Equipment Technical
Requirements document(s), but does not guarantee that the equipment will operate to
the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to connect to
the facilities of the local telecommunications company. The customer should be aware
that compliance with the above conditions may not rule out degradation of service in
some situations.
Repairs to certified equipment should be coordinated by a representative designated by
the supplier. Any repairs or alterations made by the user to this equipment may give the
telecommunications company cause to request the user to disconnect the equipment.
For their own protection, users should ensure that the electrical ground connections of
the power utility, telephone lines, and internal metallic water pipe system, if present, are
connected together. This precaution is particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
17.8.4 NEBS COMPLIANCE
• GR-1089-CORE NEBS
Section 6 DC Potential Difference
Section 8 Corrosion Requirements
• GR-1089-CORE NEBS Level 3
Section 2 ESD
Section 3.1, 3.2 EMI Emissions
Section 3.3 Immunity
Section 4 Lightning and AC Power Fault
Section 5 Steady State Power Induction
Section 7 Electrical Safety Analysis
Section 9 Bonding and Grounding
• GR-63-CORE NEBS
Section 2 Spatial Requirements
Section 4.1.3 Altitude
Section 4.6 Acoustic Noise
Section 4.7 Illumination Requirements
• GR-63-CORE NEBS Level 3
Section 4.1.1 Transportation and Storage
Section 4.1.2 Operating Temperature and Humidity Criteria
Section 4.2.3 Equipment Assembly Fire Test
Section 4.3.1 Packaged Equipment Shock Criteria
Section 4.3.2 Unpackaged Equipment Shock Criteria
Section 4.4.1 Earthquake Environment and Criteria