Datatek DT-4180 - Manual (Page 90)

9 4 8 0 , 4 1 8 0 , 4 2 8 0 , 4 2 8 4 4 0 0 0 X A U s e r M a n u a l
04/09/09
90
13.18 The RJ45 to RJ45 Crossover Console Cable
The RJ45 to RJ45 console cable implements a three wire interface for attaching to a
console on a 4000XA, 4180, 4280, or 4284. There is signal looping at either end. It is
used to connect a serial console directly to a 4000, 4000XA, 4180, 4280, 4284, a Datakit
SAM port, or a Datakit TY port. No adapter is required. It may also be used in
conjunction with an Asynchronous DCE or DTE adapter to provide console interfaces for
personal computers or terminals where looped signals are required.
The diagram for the console cable is as follows:
1 2 3 4 5 6 7 8
RJ45 Female Pin Numbering
RJ45 Male
1
2
3
4
5
6
7
8
RJ45 to RJ45 Console Cable
RJ45 Male
Note: This cable for use on console ports only.
1
2
3
4
5
6
7
8
Comcode: 408198133