Datatek DT-4180 - Manual (Page 16)

9 4 8 0 , 4 1 8 0 , 4 2 8 0 , 4 2 8 4 4 0 0 0 X A U s e r M a n u a l
04/09/09
16
4 I N S T A L L A T I O N
This chapter contains the steps needed to install and cable the 4xxx. The 9480 is
directly attached to the network element via a DB25 interface. A #2 Phillips and medium-
sized flathead screwdrivers are required.
4.1 REQUIRED EQUIPMENT
To install either a rack-mounted or stand-alone device, the following items are needed:
• One
4000XA, 4180, 4280, 4284, or 9480 unit
• For AC operation, AC power supply
• For DC operation, a strain-relief clamp for wire stabilization
Cables – refer to CABLING sections 4.4 through 4.7 below to determine specific
requirements for this installation. Note: Shielded cables must be used in order to
maintain compliance with EMC requirements.
For rack-mount installations only:
• An EIA standard 19-inch or 23-inch equipment rack with internal, vertical mounting
rails. Hole spacing on the vertical-mounting rail must be 1.25 inches. Use the
dimension specifications to calculate how high the rack needs to be to support the
required number of units.
• A pair of mounting brackets for each 4000XA, 4180, or 4280. The 4284 uses the IP-
DSU mounting bracket.
• The Environmental Operating Range of 5 to 40 degrees C (41 to 124 degrees F) is
necessary to maintain compliance with UL.
4.2 INSTALLATION FOR AC-ONLY OPERATION
1) Stand-Alone: Attach the provided feet to the bottom of the unit
Rack-Mount: Attach the mounting brackets to each side of the unit.
2) Stand-Alone: Place the unit in the desired location, such as a shelf in a data
equipment rack.
Rack-Mount: Fasten the unit to a 19-inch equipment rack (using appropriate rack
screws) or use extension ears for a 23-inch rack.
3) Attach data transport cables – refer to section 4.5
4) Attach console cable by plugging one end of an RJ45-terminated twisted-pair data
cable into the console interface and the other into the port of the asynchronous
device that will be used to configure or manage the unit.
5) Plug the power supply into a standard 115V AC outlet and the barrel connector on
the power supply cable into the appropriate circular connector on the faceplate.
Labeled 24VDC on the 4280, 5VDC on the 4000XA, and 4180, and 48VDC on the
4284 and 9480.