ETA Gratus Maxipasta - Manual (Page 43)

– After finishing work and before cleaning, always switch off the appliance and disconnect it
from power supply by taking the power cord connector out of the electric socket.
– Always use only one function of the appliance, never turn on several functions at the same
time (e.g. processing food in the bowl B1 and at the same time in the blender F).
– The product is intended for home use and similar (in shops, offices and similar
workplaces, in hotels, motels and other residential environments, in facilities
providing accommodation with breakfast). It is not intended for commercial use!
– Do not connect this appliance to a programmer device, a timer or any other device, which
switches power to the appliance automatically.
– Never submerge the appliance under water and do not wash under running water!
– Do not leave the appliance in operation without supervision and supervise it for the entire
time that food is being prepared!
– It is not allowed to modify the surface of the appliance in any way (e.g. using
a selfadhesive wallpaper, foils, etc.)!
– Use the appliance only in the working position in places, where there is no risk of it being
knocked over and at a suffi cient distance from sources of heat (e.g. fire stoves, electric/
gas stoves, cookers, etc.), and wet surfaces (kitchen sinks, wash basins etc.).
– Before preparation, remove possible packages from food (e.g. paper, a PE bag, etc.).
– Do not turn on the appliance without any ingredients inside!
– Use the appliance only with accessories designed for this model. The use of other
accessories may present a danger for the user.
– When mixing or blending liquids, never use a greater volume than is indicated on the bowl.
– Do not insert accessories into any body cavities.
– Never insert your fi ngers into the fi lling opening and do not use a fork, knife, spatula,
spoon, etc. Use only the supplied pusher for this purpose.
– Do not exceed the maximum continuous operating time of the appliance, see table!
– The appliance is also equipped with a mechanical safety. The cog wheel located on the
conveyor screw is designed to, in the case that bones or kitchen utensils get into the meat
mincer, to break and so prevent causing damage to the motor. If such a situation occurs,
follow the instructions in paragraph V. MAINTENANCE.
– Due to safety it is not possible to change the attachments while the drive unit is in operation.
– Allow the rotating parts to fully stop before removing the lid or the mixing bowl.
– If the funnel is empty, do not leave the extra attachment running.
– Never use the extra attachment if it is not working properly, if it fell to the ground and got
damaged. In such cases take the extra attachment to a specialized service to check its
safety and proper function.
– When assembling the extra attachment, follow the instructions for use carefully. In order
to ensure proper functioning, any other way of assembling the extra attachment is not
permissible!
– The assembled extra attachment can be attached and removed only when the drive unit is
switched off and the power cord is unplugged from the power socket.
– This extra attachment H is designed for processing of poppy seeds only! Do not
process other foodstuffs (e.g. cereals, flax and sesame seeds, corn, rice, buckwheat, dried
mushrooms, herbs, spices and coffee beans, etc.).
– Never process wet, damp or frozen poppy seeds!
– Never assemble the extra attachment H on the drive unit!
– Never adjust the coarseness of grinding while the drive unit is running!
– Make sure hair and loose pieces of clothing do not get into the attachments or into the
rotating drive to avoid risk of them tangling up in the mixing blade or the rotating drive itself.
GB
43 / 90