ETA Gratus Maxipasta - Manual (Page 56)

Pasta attachments
Wipe the pasta attachments G1 to G3 with a damp cloth after use. Do not submerge in water.
Poppy seed mill
Be very careful when cleaning the grinding discs! Make sure that the grinding edges
/ grooves of the discs do not come in contact with any hard objects which would
make them blunt and thus reduce their efficiency. We recommend that you oil the
grinding discs and pusher plate by cooking oil after washing and wiping the parts dry.
Some foods may stain the accessories in a certain way. This however has no effect on
the operation of the appliance and is not cause for a claim or complaint regarding the
appliance! After some time this staining usually goes away by itself.
Never dry plastic moulded parts above a heat source (e.g. fire stove, electric/gas stove).
Store the appliance thoroughly cleaned in a dry, dust-free location that is out of reach of
children and incapacitated persons.
Procedure for replacing a broken cog wheel
Remove the conveyor screw D1. Using an appropriate tool (e.g. a screwdriver) loosen the
screw. Remove the cog wheel D15 from the conveyor screw. Place a new cog wheel on
the conveyor screw shaft and fi rmly tighten with a screw (pic. 10).
Setting the optimal attachment height (pic. 9)
If the beater, the whisk or the kneading hook hit against the bottom of the bowl or do not
reach the mixture at the bottom of the bowl. It is necessary to set the correct height of
attachments C1, C2.or C3 Proceed as follows:
Press the release lever A1 of the multi-function head A7 and lift the head up. Into the
mount A3 in the head insert one of the attachments C1, C2, C3 and turn to secure it in
position so that it slots into its place in the head. Tilt the multi-function head A7 down to the
work position by pressing lever A1 and pressing head A7 downwards until it locks in, which
is accompanied by an audible click. Hold the attachment in one hand and with the other
release the attachment nut using an appropriate spanner. Then set the height by manually
turning the attachment clockwise or anticlockwise. The attachment will slide out of or into
the mount. The attachment should be as close as possible to the bottom and the walls of
the bowl, but it must not touch them. After setting the height properly tighten the nut, lift the
head up and remove the attachment.
VI. ENVIRONMENT
If the dimensions allow, there are marks of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specifi
ed on the product or in the accompanying documentation mean that the used electrical
or electronic products must not be disposed of together with municipal waste. For proper
disposal, hand them over at the special collection places where they will be accepted free
of charge. Suitable disposal of the product can help to maintain valuable natural resources
and to prevent possible negative impacts on the environment and human health, which
could be the possible consequences of improper waste disposal.
56
GB
/ 90