ETA Gratus Maxipasta - Manual (Page 53)

The recipe given above is only the guidance and you can use your own creativity to
prepare other various types of the pasta. In addition, you can also colour the dough e.g. by
the tomato paste to red or by the mixed spinach to green, however it is essential to keep
the ration of 50 g to 110 g of flour. If you will add the colour by the spinach or paste, 50 g of
the substance replaces one egg.
E.g. for lot of 330 g flour, 50 g spinach, 2 tablespoonful of oil and 2 tablespoonful of water
add 2 eggs; and for 220 g flour, 100 g spinach, 2 tablespoonful of oil and 2 tablespoonful of
water add 1 egg.
If you process the dough to roll of the diameter lower than the feeder hole diameter and
insert it directly to the feeder, you will achieve the best method of the dough feeding.
Pressed-out dough must be cut directly on the attachment I and let it fall into the selected
bowl. Adhering to the maximum length of pasta of 2 cm is recommended.
With this type of processing, the drive unit is not being overloaded. When the processing is
complete, switch off the food processor. The prepared pasta should be cooked within
4 hours at the latest, or distribute it onto the cloth and cover it by another cloth. Dry it only
at the room temperature.
Poppy seed mill (fig. 13)
Assembly (fig. 14)
Put carrier H1 onto cover H2. Put “fixed” grinding disc H3 onto the carrier, then start turning
with the disc slowly until the three arresting projections on the disc fit in the three created
indentations in the carrier. Now place the “moving” grinding disc (i.e. with grooves facing
each other) on the “fixed” grinding disc. Slide pusher plate H4 onto the shaft so that the
central projection faces the opening in the grinding disc. Then start turning the pusher plate
slowly until the three arresting indentations on the plate fit in the three created projections
in the disc. Finally, screw regulating disc H5 onto the carrier shaft and screw it tight with
delicacy = go easy ( CAUTION: the “moving” grinding disc must be able to rotate
freely!).
Installation of the extra attachment into the drive unit (fig. 15)
Slide the assembled poppy seed mill (with the gearwheel) onto the drive unit outlet A4 at
a 45 degree angle and by turning it slightly anti-clockwise, secure it in its horizontal position
(a click sound will be heard). To dismantle the assembled mill, press the release button A5
on the drive unit, start turning the mill slightly clockwise as far as it goes and then slide it
out of the drive unit outlet.
Setting “fineness / coarseness” of grinding (fig. 16)
Fineness of grinding is set by a turning regulating disc H5. Turning the disc clockwise
reduces the distance between the grinding discs and thus the fineness/coarseness of
grinding can be changed.
Attention
!
– As soon as the grinding discs grind/rub against each other, the finest possible degree
of grinding has been set.
– Never tighten the grinding discs by force! The discs may not “constantly” touch
each other!
GB
53 / 90