ETA Gratus Maxipasta - Manual (Page 51)

Blender (F)
Assembly and installation on the multi-function head (pic. 4 and 8)
Into the base F2 of the blender insert blade F3 and turn to secure in place. Place the lid
F1 on to the jug. Open the cover A9 by pressing button A8 Place the assembled blender
F on to the mount A10 and turn anticlockwise so that the rail on the base F2 slides into
the groove in the multifunction head. Remove the blender in the reverse sequence. When
attaching or removing the jug do not exert excessive pressure on the jug handle.
Application
The blender is designed to mix juices, milkshakes, soups, sauces, baby and dietary food,
puffy pastry dough, sponge cake dough, to make purée, etc. Remove the lid F1, insert or
pour the ingredient into the jug of the blender F and return the lid to its place. Do not fi ll
over the line MAX marked on the jug. Insert the power cord plug A11 into a power socket.
Put the appliance into operation by turning the speed dial A2 to one of the speed levels
appropriate for blending your ingredients (see table).
Attention
!
– Do not leave the blender in operation without ingredients!
– Do not remove the base F2 from the glass jug F1!
Pasta attachment (G1 - G3)
Assembly and installation on the multi-function head (pic. 11 and 12)
Slide out the cover A6, insert the attachment, which you wish to use (G1 to G3) into mount
A4 of the multi-function head A7 at an angle of approximately 45 o and secure in
a horizontal position by turning it anticlockwise (you will hear a click).
Application
The G2 and G3 attachments have differently arranged knives and create a different type of
pasta.
Recommendation
– Preparation times (processing) depend on the amount, type and quality of the used
ingredients, but as a rule it takes a few dozen seconds. The longer you process your
ingredients in the blender, the finer will be the result.
– If you will be processing a larger amount of food, separate them into individual batches
so that you do not overload the drive unit of the multi-function head.
– It is good to cut tougher ingredients into smaller pieces. The blade F3 would become
blunt unnecessarily early.
– If you wish to crush ice cubes, then their dimensions should not exceed 40x40x20mm,
otherwise the blade F3 will become blunt or the drive unit will be overloaded.
– Never pour boiling liquids into the jug F, the high temperature could damage or crack
the glass of the jug. Never remove the lid F1 while the drive unit is in operation. Dip
hard ingredients (e.g. legumes, soya beans, etc.) in water before processing.
– You may also process hot liquids up to a temperature of 80 °C, e.g. sauces, soups.
– To prevent overfl ow, never fill the jug up to the „ MAX“ with liquids that create a foam
(e.g. milk). In this case we recommend an amount of approx. 1 l.
– If you are not happy with the result, turn off the appliance and stir the ingredients with
a spatula, remove some of the ingredients or add some liquids.
i
GB
51 / 90