ETA Crustum User Manual
Page 42
42
GB
/ 97
– The appliance is portable and is fitted with a movable power cord with the plug providing
bi-polar disconnection from the electric power grid.
– If use of an extension cable is needed, please make sure the cable is in perfect condition
and conforming to applicable standards.
– Disconnect the appliance from power source immediately if the power cord is damaged.
– Use the appliance only with genuine accessories from the manufacturer.
– Do not use the appliance for purposes other than defined and described in this manual!
– The manufacturer will not be liable for defects caused by improper use of the appliance
and accessories (e.g.
degraded foods, injury, damage, fire etc.) and the warranty
provisions will void in case of non-adherence to safety measures.
II. DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (Fig. 1)
A – bread maker
A1 – control panel
A4 – view window
A2 – baking area
A5 – power cord
A3 – lid
A6 – cover
A7 – pilot lamp
B – baking pan
B1 – holder
C – kneading blades
D – measuring spoon small/large (5/15 ml)
E – measuring cup (200 ml)
F – hook remover
III. CONTROL PANEL
1) DISPLAY – BASIC SETTINGS
After turning the appliance on, the display will show basic settings (i.e.
BASIC-KLASIK
program) and a beep sound will be heard. The colon between the numbers does not flicker.
– Number 1 shows what program was selected.
– Numbers 3:00 show completion time for the program selected.
Note
During use, the display can be used to monitor the progress of the program selected. As
the program progresses, the numbers of time shown are decreasing. For one-hour heating,
0:00 is displayed on the display and the colon between the number flickers. Following
heating the programmed time is displayed on the display. The pilot lamp
A7 indicates of the
appliance.
2) START/STOP button
The button is used for turning the program on and off.
– A beep signal will be heard after pressing the
START/STOP button (short beep) and
mixing/kneading will activate within three seconds (does not apply to the program 9 and
12)
– A beep signal for about 3 seconds (long beep) will be heard after pressing and holding
the
START/STOP button for 2 seconds and the program will end. The same procedure
applies for termination of 60 minutes keeping warm of the bread maker.
3) BARVA (COLOR) button
The button is used for setting of requested browning colour of your bread (SVĚTLÝ-LIGHT,
STŘEDNÍ-MEDIUM, TMAVÝ-DARK). The (▲) on the display shows selected bread color.
Does not apply to programs 8-TĚSTO (DOUGH), 9-MARMELÁDA (JAM),