Foxconn Q67M-S - Manual (Page 78)

5
�1
Intel ® Matrix Storage Manager
The Intel ® Matrix Storage Manager technology supports RAID 0 ,RAID 1, RAID 5, and
RAID 10 (0+1) functions. It allows you to get high performance with fault tolerance, big
capacity, or data safety provided �y different RAID functions.
In this section, we will use four SATA hard disks as an example to guide you how to
configure your RAID system. There are two 149.0GBs and two 74.5GBs. A creation of
second volume will also �e well descri�ed.
In each screen, there is also a message �ar a�out each key’s function, such as <Ta�>,
<Enter>, <Del>...etc. it is to help making your selection easier.
The topic will be introduced :
Installing a new Windows XP in a brand new RAID system.
Steps to Install Serial ATA Hard Disks :
1. Install SATA hard disks into the drive �ays.
2. Connect one end of the SATA cable to motherboard’s SATA connector, and the
other end to SATA hard disk.
3. Connect SATA power ca�le to the power connector of SATA hard disk.
Before installing the SATA hard disks, make sure to turn off the computer
and unplug the power cord from the power outlet to prevent damage to the
hardware.
CA
UT
IO
N
!
■ Both AHCI and RAID modes need to install Intel ® Matrix Storage Manager
driver.
■ Set SATA mode in BIOS to AHCI, you can skip RAID BIOS creation steps,
�ut the software driver installation of Intel ® Matrix Storage Manager shall
follow the same rule as descri�ed for RAID.
WA
RNING!