Instruments and controls 5-13 – Hummer 2010 H3 User Manual

Page 127

Advertising
background image

Instruments and Controls

5-13

This light comes on during a
malfunction in one of two ways:

Light Flashing: A misfire condition
has been detected. A misfire
increases vehicle emissions and
could damage the emission control
system on the vehicle. Diagnosis
and service might be required.

The following can prevent more
serious damage to the vehicle:

.

Reduce vehicle speed.

.

Avoid hard accelerations.

.

Avoid steep uphill grades.

.

If towing a trailer, reduce the
amount of cargo being hauled as
soon as it is possible.

If the light continues to flash, when
it is safe to do so, stop the vehicle.
Find a safe place to park the
vehicle. Turn the key off, wait at
least 10 seconds, and restart the
engine. If the light is still flashing,
follow the previous steps and see
your dealer for service as soon as
possible.

Light On Steady: An emission
control system malfunction has
been detected on the vehicle.
Diagnosis and service might be
required.

An emission system malfunction
might be corrected.

.

Make sure the fuel cap is fully
installed. See Filling the Tank on
page 9‑68
.
The diagnostic
system can determine if the
fuel cap has been left off or
improperly installed. A loose or
missing fuel cap allows fuel to
evaporate into the atmosphere.
A few driving trips with the cap
properly installed should turn the
light off.

.

If the vehicle has been driven
through a deep puddle of water,
the vehicle's electrical system
might be wet. The condition is
usually corrected when the
electrical system dries out.
A few driving trips should turn
the light off.

.

Make sure to fuel the vehicle
with quality fuel. Poor fuel quality
causes the engine not to run as
efficiently as designed and may
cause: stalling after start-up,
stalling when the vehicle is
changed into gear, misfiring,
hesitation on acceleration,
or stumbling on acceleration.
These conditions might go away
once the engine is warmed up.

If one or more of these
conditions occurs, change the
fuel brand used. It will require at
least one full tank of the proper
fuel to turn the light off.

See Recommended Fuel on

page 9‑64.

If none of the above have made
the light turn off, your dealer can
check the vehicle. The dealer
has the proper test equipment
and diagnostic tools to fix any
mechanical or electrical problems
that might have developed.

Advertising