Hummer 2010 H3 - Manual (Page 175)

Infotainment System 7-21
3. Say the entire number without
pausing.
. If the system recognizes
the number, it responds
with “OK, Dialing” and dials
the number.
. If the system does not
recognize the number, it
confirms the numbers
followed by a tone. If the
number is correct, say
“Yes”. The system responds
with “OK, Dialing” and dials
the number. If the number
is not correct, say “No”.
The system will ask for the
number to be re‐entered.
Using the Digit Dial Command
1. Press and release
g
. The
system responds with “Ready”
followed by a tone.
2. Say “Digit Dial”. The system
responds with “Digit dial using
<phone name>, please say the
first digit to dial” followed by
a tone.
3. Say the digits to be dialed one at
a time. Following each digit, the
system will repeat back the digit
it heard followed by a tone.
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say “Dial”. The
system responds with “OK,
Dialing” and dials the number.
. If an unwanted number is
recognized by the system,
say “Clear” at any time to
clear the last number.
. To hear all of the numbers
recognized by the system,
say “Verify” at any time and
the system will repeat them.