Hummer 2010 H3 - Manual (Page 176)

7-22 Infotainment System
Using the Call Command
1. Press and release
g
. The
system responds with “Ready”
followed by a tone.
2. Say “Call”. The system responds
with “Call using <phone name>.
Please say the name tag”
followed by a tone.
3. Say the name tag of the person
to call.
. If the system clearly
recognizes the name tag it
responds with “OK, calling,
<name tag>” and dials the
number.
. If the system is unsure
it recognizes the right
name tag, it confirms the
name tag followed by a
tone. If the name tag is
correct, say “Yes”.
The system responds with
“OK, calling, <name tag>”
and dials the number. If the
name tag is not correct, say
“No”. The system will ask
for the name tag to be
re‐entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re‐dial Command
1. Press and release
g
. The
system responds with “Ready”
followed by a tone.
2. After the tone, say “Re‐dial”. The
system responds with “Re‐dial
using <phone name>” and dials
the last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle. Press
and release
g
to answer the call.
Call Waiting
Call waiting must be supported on
the Bluetooth phone and enabled by
the wireless service carrier to work.
. Press and release
g
to answer
an incoming call when another
call is active. The original call is
placed on hold.
. Press and release
g
again to
return to the original call.
. To ignore the incoming call,
continue with the original call
with no action.