Traction control system (tcs)/stabilitrak® light, Tire pressure light, Traction control system – Hummer 2010 H3 User Manual

Page 130: Tcs)/stabilitrak, Light -16, Tire pressure light -16, Traction control system (tcs)/stabilitrak, Light, 16 instruments and controls

Advertising
background image

5-16

Instruments and Controls

Traction Control System
(TCS)/StabiliTrak

®

Light

The StabiliTrak system or the
Traction Control System (TCS)
indicator/warning light comes on
briefly while starting the engine.

If it does not, have the vehicle
serviced by your dealer. If the
system is working normally the
indicator light will then go off.

The indicator/warning light flashes
while the StabiliTrak or TCS system
is working to control the vehicle on
a low traction surface.

If the TCS warning light comes on
and stays on while driving, the
vehicle needs service.

The light comes on when the TCS
and the StabiliTrak system is turned
off. If the TCS is off, wheel spin is
not limited. If the StabiliTrak system
is off, the system does not assist in
controlling the vehicle. Turn on the
TCS and the StabiliTrak system and
the warning light turns off.

See StabiliTrak System on
page 9‑53
and Traction Control
System (TCS) on page 9‑52
for
more information

Tire Pressure Light

For vehicles with a tire pressure
monitoring system, this light comes
on briefly when the engine is
started. It provides information
about tire pressures and the Tire
Pressure Monitoring System.

When the Light is On Steady

This indicates that one or more
of the tires are significantly
underinflated.

A tire pressure message in the
Driver Information Center (DIC),
can accompany the light. See Tire
Messages on page 5‑25
for
more information. Stop as soon as
possible, and inflate the tires to the
pressure value shown on the tire
loading information label. See Tire
Pressure on page 10‑51
for more
information.

When the Light Flashes First and
Then is On Steady

This indicates that there may be
a problem with the Tire Pressure
Monitor System. The light flashes
for about a minute and stays on
steady for the remainder of the
ignition cycle. This sequence
repeats with every ignition cycle.
See Tire Pressure Monitor
Operation on page 10‑53
for
more information.

Advertising