Leprecon LP-2000 - Manual (Page 14)

14
Recording Presets
(1) Set the page roller to the desired preset page.
(2) Make sure the keyswitch is in the Unlocked position, and press
the red RECORD button to enter Record mode.
(3) Set up the desired scene, using any combination of X and Y
faders and other presets.
(4) Press the numbered black SELECT button over the preset fader
that you wish to hold the new scene.
Editing Presets
The LP-2000 allows for easy editing of a previously recorded preset.
When the console is in Edit mode, it is possible to quickly modify an
existing preset, even while a show is being run. With all of the
preset faders down, make sure the keyswitch is set to Unlocked, and
press the red EDIT button (to the right of the keyswitch) to go into
Edit mode. (Note that the console must first be in Run mode before
entering Edit.) The yellow LED next to the EDIT button will light,
and the display screen will show:
EDIT MODE
SELECT SCENE
Choose which preset you want to edit either by pressing one of the
numbered black preset Select buttons above the faders, or simply by
moving a preset fader up past half intensity (if no other faders are
up). If a single preset fader is up when Edit mode is entered, that
preset will automatically be selected for editing. The display will
then show:
ACTIVE EDIT
PRESET XX
where "XX" is the preset number which was selected. At this point,
the output LEDs above the channel faders will no longer display the
actual output of the board, but instead will show the contents of the
preset being edited, as if the MASTER fader, PRESET Master, and the
selected preset fader were all at maximum. The faders in the Y scene
are now used to make changes to the preset, and the Y scene LEDs will
flash to indicate this. If the preset fader is up while editing is
being done, the changes being made will appear on stage as the channel
faders are moved.
To change the level of any channel in the preset, that channel's Y-
scene fader must be moved past the value stored in memory; this will
transfer control for that channel from the stored value to the actual