Leprecon LP-2000 - Manual (Page 16)

16
Editing Presets While An X Scene Is Active
(1) Make sure the Y Crossfader is set to zero (fully upward).
(2) Turn all preset faders down, make sure the keyswitch is set to
Unlocked, and press the red EDIT button to enter Edit mode.
(3) Select the desired page of the roller, then select the preset
you wish to edit by pressing its black select button.
(4) Use the Y scene channel faders to edit the levels of each
channel in the preset. A fader must be moved through its
stored position before any changes will register. Channel
levels are indicated by the channel LEDs above the X scene
faders.
(5) Press the green RUN button to store the edited preset.
Running a Show Using Presets
(1) Make sure the console is in Run mode, by pressing the green
RUN button.
(2) Set the MASTER and PRESET master faders fully on.
(3) Set the PAGE roller to the page with the desired preset(s).
(4) Bring up the individual preset faders as needed.
(5) Change the PAGE roller as needed. Any preset fader that is
up as the PAGE roller is turned will hold the current preset
until it is faded down; this "page hold" is indicated by the
preset level LED turning red, and prevents unwanted changes
in the lights on stage.