MBM Corporation AEROCUT G2 - Manual (Page 33)

３２
③ This screen allows you to input each pitch from No. 1 to No. 20. The adjacent switches
are used for selecting no operation, guillotine, or creaser. Every time the switch is
pressed, the selected operation changes.
：No operation
：Guillotine
：Crease
④ If the pitch of 0.000” is input, all the pitches after that one are corrected to 0.000” (no
operation).
⑤ Pressing SAME PITCH copies the No. 1 pitch and its relevant operation to No. 2 to No.
20 pitches.
Cutting Pitch
Correction Screen
Confirm cutting
pattern and move to
Operation Screen
Move to Cutting Pattern
Correction Screen