MBM Corporation AEROCUT G2 - Manual (Page 43)

４２
(2) If Paper scrap remains on the machine
① When the paper jams near the stacker panel or when maintenance work is done, the
stacker panel can be opened.
② Shift the right and left lock levers of the stacker panel to the inner side, and pull the upper
part by hand to open.
③ Pick up paper scraps with Tweezers and take them away.
④ With the stacker panel opened, the machine cannot be operated, resulting in Cover open
error.
⑤ To reposition the stacker panel, just close it.
⑥ If the paper scrap remains in cutter cover.
If Paper scrap remains under the Cutter cover of the machine, turn off the machine and take
off thumb screw to remove the anti-static brush setting plate. After removing plate there will
be a space. Push the paper t scrap down with Waste ejector, which comes with machine.
Caution
Power it off. Otherwise,
Injury could occur.
Cutter cover
Anti-static Brush Setting Plate
Waste ejector
Thumb screw
Stacker panel
Lock lever Lock lever