MBM Corporation AEROCUT G2 - Manual (Page 46)

４５
⑪ Perforation location warning
Correct the perforation location to fit in the value range below. The maximum value is
subject to change depending on the entered paper size.
⑫ Leading edge margin and cut mark margin warning
Correct the measurement so that the leading margin becomes larger than the cut mark
margin.
⑬ Cover open error
Safety cover or Stacker panel might be open.
Make sure to close the Safety cover and Stacker Panel is closed.
⑭ Paper jam error
Paper remains inside the machine. Remove the paper.
⑮ Timeout error 1
Paper was not fed within a set time period. Check the paper feeder.