MBM Corporation AEROCUT G2 User Manual
Page 34
33
⑥ When letting the paper pass through completely (when passing only via the perforator or
when using as the feeder), input the paper size for A and B, and the same dimension as B
for D. Input “0” for all the remaining dimensions.
⑦ Make sure for the first cut line must be 0.785” or shorter from the edge of the paper. If
you want to cut off 0.785” or more, please cut off 0.785” or less at first and then cut off
again and again. If you try to move the slitter cut line at 1.855 or more position, the slit
will be ejected on Paper ejection table instead of waste box. If you try to move the slitter
between 0.785” and 1.855” from the edge of the paper, error occurs.
⑧ If you try to move the slitter to the position that is physically impossible, the error occurs.