Montigo 30FID Traditional - Manual (Page 17)

Page 17
XG00516- 150204
I-Series Indoor Gas Fireplace
Installation
Figure 3 Sec.5 The door latch released from the door
Figure 4 Sec.5 Swing the Door away from the unit, lift over the
retaining tabs on top of the firebox. Be careful to not roll the gasket
up off the glass when reinstalling the door.
Door Installation & Removal
This appliance is supplied with a safety screen installed. The
Safety Screen is attached to the fireplace door using 4 screws,
and can be removed when necessary for outer glass cleaning.
The Fireplace Door is attached to the Firebox by way of 2 tabs
mounted to the top of the Firebox and by 2 spring loaded retainers
at the bottom underneath the Door. The Retainers at the bottom
of the unit are manipulated using a Door Tool that is supplied with
the unit. The general operation of the Door Retainers is:
a). Engage the Door Tool into the Door Retainer
b). Pull forward away from the tabs that engage it on the
bottom of the Door Frame
c). Move the retainer downward and then back underneath
the Door
d). Swing the Door outward from the unit and then lift the
Door up and over the top Tabs.
Figure 1 Sec.5 Door Tool / Bottom of Door
Engage door tool into door retainer. Pull door tool towards you and
push downwards, disengaging the door retainer from the door.
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hoooked and fully engaged.
Figure 2 Sec.5 Engaging the Door Tool into the Door Retainer