Montigo 30FID Traditional - Manual (Page 25)

Page 25
XG00516- 150204
I-Series Indoor Gas Fireplace
Installation
Standard Faceplate Offset Installation
When the standard faceplate is used the install width of the
fireplace is 30 inches. If your install is smaller than 30 inches,
you can use the offset kit, which will allow you to decrease
the install size to 28 inches. This can only be done with the
standard faceplate kit. You must install the offset kit on the
standard faceplate before installing it on the appliance.
2). Take the offset faceplate and peel the red protective plastic off
of the self-adhesive tape.
Figure 1 Sec.7 Standard Faceplate Offset Kit Contents
1). Unpack the standard faceplate kit. Take the rear faceplate
and cut 0.325 inches away from the wire pass-through hole at
the bottom right hand corner.
3). Place the rear panel from the standard faceplate over top of
the offset trim. Press down on the adhesive to guarantee good
adhesion.
4). Continue to standard faceplate installation section for
remainder of installation.
Faceplate Installation
Figure 2 Sec.7 Cutting away excess material
Figure 3 Sec.7 Peeling self-adhesive tape
Figure 4 Sec.7
Figure 5 Sec.7 Offset Trim Installed on Rear Panel of Standard Faceplate