Montigo 30FID Traditional - Manual (Page 53)

Page 53
XG00516- 150204
I-Series Indoor Gas Fireplace
Maintenance
1). By grasping the burner with both hands, angle the burner into
the rear of the firebox to engage the Mixing Tube into the Burner
Support Bracket. The Mixing Tube goes into the Burner Support
Bracket. If it does not go into the Burner Support Bracket, you
will not get the burner to line up at the front and the burner may
not operate correctly.
2). Once you have the Mixing Tube situated into the Rear Burner
Support, lower the front of the Burner over the Front Burner Supports.
Using the same small screw driver or pliers, bent the tabs just enough
that the burner cannot be moved from its position.
3). Check again that the Mixing Tube is still inside the Rear Burner
Support by grasping the rear of the Burner and pulling up. If the Mixing
Tube is properly installed, the Log Burner will not move. If the Burner
does rise up, stop and trouble shoot this situation. The Log Burner
will not operate safely if this connection is not proper.
Burner Installation
Figure 30 Sec.10
Figure 31 Sec.10 Log burner correctly installed