Montigo 30FID Traditional - Manual (Page 50)

Page 50
XG00516- 150204
I-Series Indoor Gas Fireplace
Operation
Continuous Pilot (CPI) Selection .............
(Optional)
In cold weather climates, the pilot burner can stay on
continuously to prevent condensation or cold air temperatures
near the fireplace glass. Note, some jurisdictions do no permit
use of continuous pilot system. Check local codes or contact
your Montigo dealer.
With the system in "off" position press the Mode Key, see
Figure 8 Sec.10, to index to the CPI mode icon, see Figure 22
Sec.10. Pressing the Up Arrow Key will activate the Continuous
Pilot Ignition mode (CPI). Pressing the Down Arrow Key will
return to IPI. A single "beep" will confirm the reception of the
command.
NOTE:
- Requires CPI/IPI jumper cable installed.
Figure 22 Sec.10 Continuous Pilot / Intermittent Pilot Selection
Key Lock
This function will lock the keys to avoid unsupervised operation.
To activate this function, press the Mode and Up Keys at the
same time, see Figure 23 Sec.10. To de-activate this function,
press the Mode and Up Keys at the same time.
Figure 23 Sec.10 Key Lock
Remote Control
When the Remote Control batteries are low, a Battery Icon will
appear on the LCD display of the Remote Control, see Figure
24 Sec.10, before all battery power is lost. When the batteries
are replaced this icon will disappear.
Figure 24 Sec.10 Low Battery Power Detection
Control Module
When the back-up batteries are low, a "double-beep" will be
emitted from the IFC when it receivers an On/Off command
from the Remote Control. This is an alert for a low battery
condition of the receiver and after that no more commands will
be accepted. When the batteries are replaced the "beep" will be
emitted from the receiver as soon as powered.
Low Battery Power Detection
The life span of the batteries depends on various factors:
quality of the batteries used, the number of ignitions of the
appliance, the number of changes to the room thermostat set
point, etc.