Omnia Audio Omnia.ONE - Manual (Page 129)

110
[None] – No Channel inversion is performed (factory default)
[Both] – Both left and right channel phase is inverted.
“Both” is typically selected if it sounds “better” to an announcer (monitoring themselves
in headphones using the output of the processing) than “None”. One of the two settings
should. The goal is to make the relative phase of the headphone feed more in phase with
the announcer’s own bone conduction. Once set, this setting should remain the same for
all announcers using the same headphone feed.
[L] – Only the left channel phase is inverted.
[R] – Only the right channel phase is inverted.
NOTE: These settings are present as a convenience to correct 180-degree stereo phase
errors in the input audio to the processor or in another device after the processor.
Mono Mode
Allows input signal routing to be reconfigured as follows:
[STEREO] - Factory default. Left and Right input channels are routed to the left and right
inputs to the DSP processing chain.
[Mono L] - Configures the DSP processing chain to have both the Left and Right internal
channels fed only from the Left Channel of the input source selected. Note that this
selection is active in all sources selected as Primary and Secondary (Failover) audio
sources.
[Mono R] - Configures the DSP processing chain to have both the Left and Right internal
channels fed only from the Right Channel of the input source selected. Note that this
selection is active in
all sources selected as Primary and Secondary (Failover) audio
sources.
[Mono L+R] - Configures the DSP processing chain to have both the Left and Right
internal channels fed from the sum of the Left Channel and Right Channels of the input
source selected. Note that this selection is active in all sources selected as Primary and
Secondary (Failover) audio sources.
[SWAP] - Configures the DSP processing chain to swap the Left and Right internal
channels, that is, the DSP Left Channel is fed from Right Channel input and the DSP
Right Channel is fed from the Left Channel input. Note that this selection is active in all
sources selected as Primary and Secondary (Failover) audio sources.
<-Exit
Click on this option to return to the Input/Output menu.
Output
There are seven controls and the “FM Options” (FM Style Only) or “AM Options” (AM Style Only)
submenus under the heading “Output” and each will be explained in the order in which they appear in
the menu:
<-Exit
Click on this option to return to the Input/Output menu.