Omnia Audio Omnia.ONE - Manual (Page 137)

118
Electronically balanced.
Input impedance 10k ohms resistive.
Maximum Input Level: +22 dBu.
Nominal Input Level: +4dBu, which nets a -18dBFS input meter reading on a steady-
state signal when the Input Gain control is set to 0.0dB. Program material with a nominal
average level (VU reading) of +4dBu will typically produce peak readings on the input
meter in the range of -12 dBFS to -6dBFS. This is the correct operating level.
A/D Conversion:
Crystal Semiconductor CS5361, 24 bit 128x over-sampled delta sigma
converter with linear-phase anti-aliasing filter. Pre-ADC anti-alias filter,
with high-pass filter at <10 Hz.
Connectors:
Two, EMI-suppressed XLR-female. Pin 1 chassis ground, Pin 2 "Hot".
Analog Audio Output:
Left/Right Stereo. Electronically balanced.
Output Impedance 20 ohms.
Minimum load Impedance: 600 ohms.
Output Level adjustable from -2 dBu to +22dBu peak in 0.1dB steps.
D/A Conversion:
Crystal Semiconductor CS4391, 24 bit, 128x oversampled.
Connectors:
Two, EMI-suppressed XLR-male. Pin 1 chassis ground, Pin 2 “Hot".
Digital Audio Input:
Configuration: Stereo per AES/EBU standard, CS8420 Digital Audio
Transceiver with 24 bit resolution, software selection of stereo, mono
from left, mono from right or mono from sum. Automatically accepts
and locks to input sample rates between 32 and 108 kHz.
Connector:
EMI-suppressed RJ-45 female pinned according to StudioHub+
 standards. Transformer
isolated, balanced, and floating according to AES3 standard.
Digital Audio Output:
Stereo per AES3 standard. Digital Output sample rate can lock to the input, lock to an
additional external sync source, or use the internal 48kHz rate.
Connector:
EMI-suppressed RJ-45 female according to StudioHub+
 standards.
Transformer isolated, balanced, and floating according to AES3 standard.
Digital Output Level:
-24.0 to 0.0 dBFS peak, software adjustable in 0.1dB steps.
External Sync Input:
External Sync: Allows the output sample rate to be synchronized to an AES3 signal
applied to the Ext. Sync input connector. (Does not accept Word Clock inputs)
Connector:
EMI-suppressed RJ-45 female according to StudioHub+
 standards.
Transformer isolated, balanced, and floating according to AES3 standard.
External Sync Range:
Automatically accepts sample rates between 32kHz and 96kHz.
Connector:
EMI-suppressed RJ-45 female pinned according to StudioHub+
 standards, Transformer
isolated, balanced, and floating according to AES3 standard.