Orion System System Manager TS II In-House - Manual (Page 14)

Zone
Zone
Main Screen Functions
SMTS II Technical Guide 14
Entering Your System Manager
Passcode
NOTE:
There are three available passcode levels. Level 1 defaults to
1111, Level 2 defaults to 2222, and Level 3 defaults to 3333. These defaults
can be changed by anyone who logs in at Level 3.
When you power-up your System Manager TS II, the message
System
Secured
is displayed on the bottom left corner of the Main Screen.
Touch the
< Login>
icon found on bottom left of the
Main Screen and type the default Level 3 passcode of
“
3333
” using the number keypad to gain access to all
setpoint and confi guration items. See Figure 10.
First Things First
The fi rst thing you need to do when setting up your Touch Screen is
to Login. The second thing you need to do is establish user passcodes.
The third thing you need to do is set the clock. After you complete
these simple tasks, you are ready to set your system’s settings,
view controller status screens, and change schedules and setpoints.
NOTE: Do not attempt to make changes to the Touch Screen
while the Unit Controller is initializing. This can cause
programming errors.
Main Screen
Once you have connected your System Manager TS II to a controller
and have powered it up with the proper power supply, the Main Screen
will appear. See Figure 9.
Figure 10: Login Screen
Enter the 4 digit Passcode
for the required Level.
Level #1:
Can change space setpoints.
Level #2:
Can change schedules.
Level #3:
Can change all setpoints.
Esc 1 2 3
4
7
- 0
.
9 8
5 6
OK
<<
Currently: ****
DATA ENTRY
Logging In
Figure 9: Main Screen
NOTE: For security reasons, the current passcode characters
displayed at the top of the screen are never shown and
appear as asterisks.
Touch
<OK>
. Touch
<Esc>
if you accessed this screen by mistake and
do not wish to change the current access level.
The Login Screen will automatically close, and the passcode will be
tested against all previously defi ned passcodes to determine the pass-
code’s access level.
If 3333 is still the active Level 3 code, the status message System
Access Level 3 will now be displayed on the bottom left corner of
the Main Screen.
NOTE:
System Access will automatically default to
System
Secured
after time set for Backlight Timeout in the
System Manager Settings Screen (see Figure 15, page
19). If timeout is set to zero, the passcode will timeout
after two minutes.
Revised 10/2/12