Super Systems XGA Viewer - Manual (Page 11)

XGA Viewer Operations Manual
Super Systems Inc. Page 11 of 46
• Click “Local Area Connection” and choose “Properties”
• Select “Internet Protocol (TCP/IP)” in the list box and choose “Properties”.
On this screen you will need to choose the “Use the following IP address” option and enter the
values listed above. Be sure to confirm and close all dialogs after making your changes.
Ethernet Network Connection
Another common configuration is to have the PC/laptop connected to the same local area
network as the analyzer.
Figure 11 - Ethernet network connection
Figure 12 - Location of Ethernet port for cable connection
NOTE: Some PGA units will have only one Ethernet port. If only one is available, use that one.
To get this configuration working correctly you must set the TCP/IP settings of the analyzer to
be compatible with your network. Your PC should already be configured correctly.
Ask your IT department or network administrator for appropriate IP Address / Net Mask /
Gateway settings.