Tech Source Raptor 4000 Series (for Linux) - Manual (Page 21)

Raptor 4000 Series: Reference Manual
©2009 Tech Source Inc. 15 Part #65-0271-01
BusID of PCI:41:0:0
. If you are
experiencing a problem starting the Xserver,
please verify the BusID of the card in
xorg.conf
match the BusID reported by
the system.
Option "Device": This field specifies the device name assigned
to each head on the Raptor 4000 Series card.
The first head seen by the system will be
/dev/rapafp0
and the second will be
/dev/rapafp1
.
Option "Mode": This field specifies pixel modes.
8
8-bit PsuedoColor
24
24-bit True Color
8+8
Two 8-bit PseudoColor visuals
8+24
8-bit PseudoColor & 24 bit True Color visuals
mox24
MOX, 8-bit Normal, 21-bit Group, 13-bit
Absolute
mox32
MOX, 8-bit Normal, 24-bit Group, 21-bit
Absolute
ScaleCursPos
This Boolean field option is useful when
monitors of different screen sizes are used
together in a multi-screen configuration. When
the cursor crosses screen boundaries, its
position on the new screen will be adjusted to
be proportional to where it was on the
previous screen.
Sync
This field option is used to override DDC info.
The
xorg.conf
resolution line is used to
drive only digital panels. For an analog signal,
this field should be commented out.
TranspColor
This field option is only used while in 8+8
mode. It allows the user to specify the RGB
color values associated with the transparent
color of the overlay. If an application is