AML M2500 Decoder - Manual (Page 11)

7
Step 9: With the power supply connected, the "POWER" display on the
front panel of the reader will display RED and the reader will BEEP
twice. Approximately 1/2 second later the display will change to
GREEN.
Step 10: If the reader has been installed correctly, you should be able to
type on the terminal's keyboard and communicate with the host
computer system.
Step 11: The bar code reader is now operational and ready to use. The
terminal is fully functional and you may enter data via the keyboard
like you did prior to installation. To enter bar code data, simply
scan the bar code and the data will be transmitted to the host
system just like it was typed in from the terminal's keyboard.
Step 12: The reader is shipped from the factory with the serial port
parameters set to the following defaults:
BAUD RATE: 9600
DATA BITS: 8
PARITY: NONE
OUTPUT DATA: ASCII
DUPLEX MODE: FULL
NOTE: The reader's serial port parameters must be set
to match the terminal. Check your terminal's
serial port parameters against those listed above.
If any parameters are different, the reader must
be set to match the terminal. Proceed to the
section of the manual entitled CHANGING THE
DEFAULT SETTINGS.