AML M2500 Decoder - Manual (Page 37)

33
CODABAR
0) CODABAR DECODER
ON * Enable reading CODABAR labels.
OFF Disable reading CODABAR labels.
1) SEND START/STOP
ON Transmit the CODABAR start/stop characters.
OFF * Do not transmit the CODABAR start/stop characters.
2) CLSI FORMATTING
ON The reader will insert a blank after the 1st, 5th, and
10th characters of a 14-character CODABAR label.
The label length does not include the start and stop
characters.
OFF * Disable CLSI formatting.
3) CLSI CHECK DIGIT
ON Enable the CLSI check digit. When this option is
enabled, all fourteen digit numeric bar codes must
contain a valid check digit.
OFF* Disable the CLSI check digit. Check digit verification will
not be performed.
CODE 128
0) CODE 128 DECODER
ON * Enable reading Code 128 labels.
OFF Disable reading Code 128 labels.
1) UCC-128 VERIFICATION
ON A valid MOD 10 CHECK DIGIT is required on UCC-
MOD 10 bar codes. (Applies to 20-digit serial
shipping container bar codes.)
OFF * UCC-MOD 10 bar codes are accepted without valid
MOD 10 CHECK DIGITS.
2) SEND MOD 10 CHECK DIGIT
ON * Transmit the MOD 10 CHECK DIGIT with the bar
code entry.
OFF Do not transmit the MOD 10 CHECK DIGIT.