AML M2500 Decoder User Manual
Page 56
52
Step 6:
Scan the following "CLONE" bar code:
Step 7:
Once the clone information has been transmitted, take any steps
required to save the information on the computer.
Step 8:
From the SOURCE reader, scan EXIT (saving OR ignoring
changes) on the READER SETUP MENU.
Step 9:
Disconnect the SOURCE reader from all cables leading to the
computer.
Step 10:
Plug the 9 pin end of the PC CLONE CABLE into the reader which
is to receive the clone information (denoted as the "TARGET"
reader). The TARGET reader's connector, located on the rear
panel, is labeled "HOST".
Step 11:
At the computer, run the communications program. Note that the
communications BAUD RATE must be set to match the TARGET
reader's BAUD RATE (the default setting is 9600).
Step 12:
Set the communications program to TRANSMIT. The reader will
beep twice, pause, and beep three times more, indicating the
following:
2 beeps:
indicate the clone information was received
3 beeps:
indicate the reader is now configured
Step 13:
Now you are ready to disconnect the newly configured reader from
all cables leading to the computer.
Step 14:
Repeat steps 10 -14 for each additional reader to be cloned.
CLONE