AML M2500 Decoder - Manual (Page 45)

41
TERMINATION CHARACTER
The optional TERMINATION CHARACTER is transmitted at the end of
the data. This option applies to bar code, mag stripe, and serial data.
If a USER DEFINED TERMINATION CHARACTER is desired, select
setting (4) below, then scan a single character from the FULL ASCII
section of the MENU.
0) NONE
1) HORIZONTAL TAB (ASCII 09)
2)* CARRIAGE RETURN (ASCII 13)
3) CARRIAGE RETURN & LINEFEED
(ASCII 13 & ASCII 10)
4) USER DEFINED TERMINATION CHARACTER
BEEP LENGTH & TONE
Settings (0-3) set the LENGTH of the BEEP. Settings (4-7) set the
TONE (pitch) of the BEEP. Setting (8), when selected, will override the
other BEEP selections and shut off the BEEP.
LENGTH:
0) SHORT
1)* MEDIUM SHORT
2) MEDIUM LONG
3) LONG
TONE:
4) LOW
5) MEDIUM LOW
6)* MEDIUM HIGH
7) HIGH
OFF:
8) NO BEEP