AML M2500 Decoder - Manual (Page 51)

47
OPTIONS #1
0) SEND BAR CODE TYPE ID
ON Transmit the bar code identifier character at the
beginning of the bar code data. There is one space
between the ID character and the bar code data. The
identifier characters are defined below:
A CODE 39
B UPC-A
C UPC-E
D EAN-13
E EAN-8
F INTERLEAVED 2 of 5
OFF * Do not transmit BAR CODE TYPE ID.
1) DUPLICATE READS ALLOWED
ON * Enable reading the same bar code multiple times.
OFF Disable reading the same bar code twice in a row.
2) LASER / CCD TIMEOUT (0 - 9)
If the LASER or CCD has not read a bar code within the
designated time period, the device will be turned off. Select
from 0 to 9 seconds. The default is 1 second.
CAUTION: IF THE ABOVE OPTION IS SET AT ZERO (0)
SECONDS, IT WILL OVERRIDE THIS SAFETY
FEATURE.
3) LASER / CCD TRIGGER SHUTOFF
ON * Releasing the trigger will turn off the LASER or CCD.
OFF The LASER or CCD will continue to run until a
successful read or until the timeout period (from
option (2), LASER/CCD TIMEOUT) lapses.
NOTE: To use "Blink Mode" with a CCD or laser, set
this option OFF, and set option (4), LASER/CCD
CONTINUOUS RUN, ON. (Note that "Blink
Mode" will not operate properly for lasers which
employ thermal shut-down.)
G CODABAR
H CODE 128
I CODE 93
J MSI/PLESSEY
K CODE 11