H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 111)

9-7
Table 9-2 Ethernet interface configuration prerequisites
Hardware Ethernet interface configuration prerequisites
LS8M1WCMA0
LSQM1WCMB0
LSBM1WCM2A0
LSRM1WCM2A1
No special requirements. You can directly configure
Ethernet interfaces on the switch.
To configure wireless features during the configuration
process, log in to the access controller module with the
oap connect slot slot-number command.
Switches
installed
with access
controller
modules
Access
controller
modules
LSWM1WCM10
LSWM1WCM20
No special requirements. You can directly configure
Ethernet interfaces on the switch.
To configure wireless features during the configuration
process, log in to the access controller module with the
mcms connect [ slot slot-number ] system system-name
command.
Unified
switches
WX3024
WX3010
WX3008
Use the oap connect slot 0 command on the access
controller engine to log in to the switching engine.
WX6103
Use the oap connect slot 0 command on the active main
control board to log in to the switch interface board.
Access
controllers
WX5002
WX5002V2
WX5004
No special requirements. You can directly configure a GE
interface on the access controller.
Network requirements
As shown in Figure 9-1 , Agent is connected to a configuration terminal through its console port and to
Server through Ethernet cables.
Gather performance statistics on received packets on GigabitEthernet 1/0/1 through RMON Ethernet
statistics table, and thus the administrator can view the statistics on packets received on the interface at
any time.
Figure 9-1 Network diagram for RMON
Configuration procedure
# Configure RMON to gather statistics for interface GigabitEthernet 1/0/1.