H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 26)

3-12
Volume Module Feature WX3024 WX3010 WX3008
Storage media supported Flash Flash Flash
Device management
configuration
License
24 APs at most by
default, and can be
extended to 48 APs. 12 APs at most by
default, and can be
extended to 24 APs.
No
Hot AC backup No No No
WLAN Configuration
Guide
WLAN services configuration
Maximum number of SSIDs
supported
64 64 64
Combo port configuration No No No
Shutting down an Ethernet
interface
No on GE1/0/1 of the
access controller engine
and GE1/0/29 on the
switching engine No on GE1/0/1 of the
access controller engine
and GE1/0/29 on the
switching engine No on GE1/0/1 of the
access controller engine
and GE1/0/29 on the
switching engine
Configuring flow control on an
Ethernet interface
No No No
Ethernet interface
configuration
Loopback detection on an
Ethernet interface
Internal loopback testing
supported on GE
interfaces only Internal loopback testing
supported on GE
interfaces only Internal loopback testing
supported on GE
interfaces only
Link aggregation
configuration
Link aggregation configuration No No No
MSTP Configuration STP No No No
Layer 2 forwarding
configuration
Layer 2 forwarding No No No
Layer 2 – LAN
Switching
Configuration Guide
Port mirroring configuration Port mirroring configuration No No No
DNS configuration IPv6 DNS configuration No No No
IP performance optimization
configuration Configuring ICMP to send
error packets
No No No
Adjacency table
configuration Displaying and maintaining an
adjacency table
Yes Yes Yes
Layer 3 – IP Services
Configuration Guide
IPv6 basics configuration IPv6 basics configuration No No No