H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 126)

10-12
To do… Use the command… Remarks
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name Optional
See Table 10-2 for default channel
names.
Configure the channel through
which system information can be
output to the log buffer and specify
the buffer size
info-center logbuffer [ channel
{ channel-number | channel-name }
| size buffersize ] *
Optional
By default, system information is
output to the log buffer through
channel 4 (known as logbuffer) and
the default buffer size is 512.
Configure the output rules of the
system information
info-center source
{ module-name | default } channel
{ channel-number | channel-name }
[ debug { level severity | state
state } * | log { level severity | state
state } * | trap { level severity |
state state } * ] *
Optional
See Default Output Rules of
System Information .
Configure the format of the
timestamp
info-center timestamp
{ debugging | log | trap } { boot |
date | none }
Optional
The time stamp format for log, trap
and debugging information is date
by default.
Outputting System Information to the SNMP Module
The SNMP module receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the SNMP module.
To monitor the AC running status, trap information is usually sent to the SNMP network management
station (NMS). In this case, you need to configure to send traps to the SNMP module, and then set the
trap sending parameters for the SNMP module to further process traps. For more information, see
SNMP in the Network Management and Monitoring Configuration Guide.
Follow these steps to configure to output system information to the SNMP module:
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
See Table 10-2 for default channel
names.
Configure the channel through
which system information can be
output to the SNMP module
info-center snmp channel
{ channel-number | channel-name }
Optional
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).