Outputting log information to a linux log host, Network requirements, Configuration procedure – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 132
10-18
In the above configuration, local4 is the name of the logging facility used by the log host to receive logs.
info is the information level. The Unix system will record the log information with severity level equal to
or higher than informational to file /var/log/Device/info.log.
Be aware of the following issues while editing file /etc/syslog.conf:
z
Comments must be on a separate line and begin with the # sign.
z
No redundant spaces are allowed after the file name.
z
The logging facility name and the information level specified in the /etc/syslog.conf file must be
identical to those configured on the AC using the info-center loghost and info-center source
commands; otherwise the log information may not be output properly to the log host.
Step4 After log file info.log is created and file /etc/syslog.conf is modified, you need to issue the following
commands to display the process ID of syslogd, kill the syslogd process and then restart syslogd
using the –r option to make the modified configuration take effect.
# ps -ae | grep syslogd
147
# kill -HUP 147
# syslogd -r &
After the above configurations, the system will be able to record log information into the log file.
Outputting Log Information to a Linux Log Host
Network requirements
z
Send log information to a Linux log host with an IP address of 1.2.0.1/16;
z
Log information with severity higher than informational will be output to the log host;
z
All modules can output log information.
Figure 10-4 Network diagram for outputting log information to a Linux log host
Configuration procedure
Before the configuration, make sure that there is a route between AC and PC.
1) Configure
AC
# Enable information center.
<Sysname> system-view
[Sysname] info-center enable
# Specify the host with IP address 1.2.0.1/16 as the log host, use channel loghost to output log
information (optional, loghost by default), and use local5 as the logging facility.
[Sysname] info-center loghost 1.2.0.1 channel loghost facility local5