Sysname, Module, Level (severity) – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 121: Digest, Source, Content
10-7
whereas that of the system information sent from the information center to the other destinations is with
a precision of milliseconds.
sysname
Sysname is the system name of the current host. You can use the sysname command to modify the
system name. (For more information, see Basic System Configuration in the Fundamentals Command
Reference)
%%
This field is a preamble used to identify a vendor. It is displayed only when the output destination is log
host.
nn
This field is a version identifier of syslog. It is displayed only when the output destination is log host.
module
The module field represents the name of the module that generates system information. You can enter
the info-center source ? command in system view to view the module list.
level (severity)
System information can be divided into eight levels based on its severity, from 0 to 7. See
for
definition and description of these severity levels. The levels of system information generated by
modules are predefined by developers, and you cannot change the system information levels. However,
you can configure to output information of the specified level using the info-center source command.
digest
The digest field is a string of up to 32 characters, outlining the system information.
For system information destined to the log host:
z
If the character string ends with (l), the information is log information
z
If the character string ends with (t), the information is trap information
z
If the character string ends with (d), the information is debugging information
For system information destined to other destinations:
z
If the timestamp starts with a %, the information is log information
z
If the timestamp starts with a #, the information is trap information
z
If the timestamp starts with a *, the information is debugging information
source
This field indicates the source of the information, such as the slot number of a board, IRF member ID,
IRF member ID and slot number, or the source IP address of the log sender. This field is optional and is
displayed only when the output destination is the log host.
content
This field provides the content of the system information.